Table of Contents
Advertisement
ID70 Motherboard User Manual /
Engineering Spec.
Chapter 2
Installations
2.1
Memory Module（SO-DIMM）Installation
The ID70 Motherboard provides one 204-pin SODIMM slot. The socket supports up
to 4GB DDR3 800/1066 SDRAM. When installing the Memory device, please follow
the steps below：
Step.1. Firmly insert the SO-DIMM at an angle into its slot. Align the SO-DIMM on
the slot such that the notch on the SO-DIMM matches the break on the slot.
Step.2. Press downwards on SO-DIMM until the retaining clips at both ends fully
snap back in place and the SO-DIMM is properly seated.
Caution
!
The SO-DIMM only fits in one correct orientation. It will cause
permanent damage to the development board and the SO-DIMM if
the SO-DIMM is forced into the slot at the incorrect orientation.
ID70 Motherboard User Manual
7
Advertisement
Table of Contents
