Adjusting The Brake Pedal Position; Adjusting The Rear Brake Light Switch - Yamaha TDM900 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Adjusting the brake pedal
position
1
2
3
4
1. Distance between brake pedal and footrest
5
The top of the brake pedal should be
positioned approximately 32.0 mm
6
(1.26 in) below the top of the footrest as
shown. Periodically check the brake
7
pedal position and, if necessary, have a
Yamaha dealer adjust it.
8
WARNING
A soft or spongy feeling in the brake
9
pedal can indicate the presence of
air in the hydraulic system. If there is
air in the hydraulic system, have a
Yamaha dealer bleed the system be-
fore operating the motorcycle. Air in
EAU22240 the hydraulic system will diminish
the braking performance, which may
result in loss of control and an acci-
dent.
1
EWA10690
Adjusting the rear brake light
switch
1. Rear brake light switch
2. Rear brake light switch adjusting nut
The rear brake light switch, which is ac-
tivated by the brake pedal, is properly
adjusted when the brake light comes
on just before braking takes effect. If
necessary, adjust the brake light switch
as follows.
Turn the adjusting nut while holding the
rear brake light switch in place. To
make the brake light come on earlier,
turn the adjusting nut in direction (a). To
make the brake light come on later, turn
the adjusting nut in direction (b).
6-21
EAU22270
1
(b)
(a)
2