Coolant - Yamaha TDM900 Owner's Manual

Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter element replace-
ment:
3.80 L (4.02 US qt)
(3.34 Imp.qt)
With oil filter element replace-
ment:
3.90 L (4.12 US qt)
(3.43 Imp.qt)
CAUTION:
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G Make sure that no foreign mate-
rial enters the crankcase.
9. Start the engine, and then let it idle
PERIODIC MAINTENANCE AND MINOR REPAIR
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
10. Turn the engine off, and then
check the oil level and correct it if
necessary.
ECA11620

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
NOTE:
NOTE:
The coolant should be between the
minimum and maximum level marks.
6-10
1. Place the vehicle on the center-
stand.
G
The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
G
Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Check the coolant level in the cool-
ant reservoir.
EAU20070
2
EAU20101
3
4
5
6
7
8
9