Siemens OP5 Equipment Manual page 138

System Messages
Message Cause
$ 135 Mode change
$ 200 Backup battery voltage has fallen
below minimum value or:
wrong battery type inserted
$ 201 Error during clock chip write (hard-
ware error)
$ 202 Error when reading date
$ 203 Error when reading time
$ 204 Error when reading day
$ 205 Printer not ready and internal stor-
age of print jobs is no longer pos-
sible (capacity exceeded)
$ 206 Printer not ready, print job will be
stored temporarily
$ 207 Print job was aborted
$ 210 Internal error
$ 212 Internal error
$ 213 Offline mode not possible at present
$ 214 The job number sent by PLC is too
high
$ 217 The addresses of two variables
$ 218 overlap
$ 220 Printer buffer overflowed, messages
$ 221 have been lost
$ 222 Event buffer full to remaining
buffer space
$ 224 Event buffer full; buffer partially
deleted and forced printout initiated
$ 225 Alarm buffer full to remaining
buffer space
$ 227 Alarm buffer full; buffer partially
deleted and forced printout initiated
$ 229 Keyboard connector faulty or loose
(hardware fault)
B-4
Action
Replace battery
Return device for repair
Re-enter date (return OP for repair)
Re-enter time (return OP for repair)
Re-enter day (return OP for repair)
Ready printer or disable message log
Ready printer
Check printer, cable and connector
Refer to Action for internal errors
Refer to Action for internal errors
Try mode change again later
Check PLC-user program
Modify configuration
(variable)
Delete buffer or configure smaller remaining
buffer space
Delete buffer or configure smaller remaining
buffer space
Return device for repair
( ) J31069-D0840-U001-A2-7618
Manual OP5, OP15