Siemens OP5 Equipment Manual page 142

System Messages
Message Cause
$ 533 No connection between OP and
floppy disk station
Connection cable not plugged in
or is defective
Error on the floppy disk station
Floppy disk station not ready
$ 534 No more memory space on the
floppy disk
$ 535 No floppy disk inserted
Floppy disk defective
Floppy disk not formatted
$ 536 Malfunction in the connection be-
tween OP and floppy disk station
Connection cable defective or
not plugged in correctly
$ 537 Read access to blank floppy disk
$ 538 Simultaneous access to data record
via job and operator input
$ 540 Maximum number of data records
already set up
$ 600 Wrong parameter transferred by
ProTool/Lite
(overflow warning)
$ 601 Wrong parameter transferred by
ProTool/Lite
(message log)
$ 602 Wrong parameter transferred by
ProTool/Lite
(remaining buffer size)
$ 604 Message not configured for a set
message bit
$ 613 Data block does not exist or is too
short
$ 615 Line to be output is larger than the
reserved print memory or the num-
ber of control sequences is too large
$ 616
$ 617
B-8
Action
Insert a blank, formatted floppy disk and trig-
ger transfer again.
Insert new, formatted floppy disk
Repeat access which was not executed
Set required value by means of standard
screen or PLC
Set required value by means of standard
screen or PLC
Re-configure and repeat download of required
value
Configure messages and transfer
Create DB of requisite length in PLC
Check configuration for log
See Internal Errors
( ) J31069-D0840-U001-A2-7618
Manual OP5, OP15