Toro Snowthrower Safety - Toro 38645 Operator's Manual

Never attempt to make any adjustments while the
engine is running, except where specifically
recommended by Toro.
Let the engine and the snowthrower adjust to the
outdoor temperature before starting to clear
snow.
Operating any powered machine can result in
foreign objects being thrown into the eyes.
Always wear safety glasses or eye shields while
operating, adjusting, or repairing the
snowthrower.
Operation
Do not put your hands or feet near or under
rotating parts. Keep clear of the discharge
opening at all times.
Exercise extreme caution when crossing gravel
drives, walks, or roads. Stay alert for hidden
hazards or traffic.
After striking a foreign object, stop the engine,
remove the wire from the spark plug, thoroughly
inspect the snowthrower for any damage, and
repair the damage before operating the
snowthrower.
If the unit should start to vibrate abnormally, stop
the engine and check immediately for the cause.
Vibration is generally a warning of trouble.
Stop the engine whenever you leave the
operating position, before unclogging the
auger/impeller housing or discharge chute, and
when making any repairs, adjustments, or
inspections.
When cleaning, repairing, or inspecting, make
certain that the auger/impeller and all moving
parts have stopped. Disconnect the spark plug
wire and keep the wire away from the spark plug
to prevent someone from accidentally starting the
engine.
Do not run the engine indoors, except when
starting it and for moving the snowthrower in or
out of the building. Open the outside doors;
exhaust fumes are dangerous.
Do not clear snow across the face of slopes.
Exercise extreme caution when changing
direction on slopes. Do not attempt to clear steep
slopes.
Never operate the snowthrower without proper
guards or other safety devices in place.
Never operate the snowthrower near glass
enclosures, automobiles, window wells, and
drop-offs without properly adjusting the snow
discharge angle. Keep children and pets away.
Do not overload the machine capacity by
attempting to clear snow at too fast a rate.
2
Look behind and use care when backing up with
the snowthrower.
Never direct the discharge at bystanders or allow
anyone in front of the unit.
Disengage the power to the auger/impeller when
the snowthrower is being transported or when not
in use.
Use only attachments and accessories approved
by Toro, such as wheel weights, counterweights,
and cabs. (Contact an Authorized Service Dealer
for accessories available for your snowthrower.)
Never operate the snowthrower without good
visibility or light. Always be sure of your footing,
and keep a firm hold on the handle. Walk; never
run.
Maintenance and Storage
Check all fasteners at frequent intervals for
proper tightness to be sure that the equipment is
in safe working condition.
Never store the machine with fuel in the fuel tank
inside a building where ignition sources are
present, such as hot water and space heaters
and clothes dryers. Allow the engine to cool
before storing in any enclosure.
Always refer to this operator's manual for
important details if the snowthrower is to be
stored for an extended period.
Maintain or replace safety and instruction labels
when necessary.

Toro Snowthrower Safety

The following list contains safety information specific
to Toro products or other safety information that you
must know.
Rotating rotor auger/impeller can cut off or
injure fingers or hands. Stay behind the
handles and away from the discharge opening
while operating the snowthrower. Keep your
face, hands, feet, and any other part of your
body or clothing away from moving or
rotating parts.
Before adjusting, cleaning, inspecting,
troubleshooting, or repairing the snowthrower,
stop the engine, remove the key, and wait for
all moving parts to stop. Disconnect the wire
from the spark plug and keep it away from the
spark plug to prevent someone from
accidentally starting the engine.
To unclog the discharge chute, stay in the
operating position and release the left hand
(traction) lever. While running the auger/impeller,
push down on the handles to raise the front of the
snowthrower a few inches (centimeters) off the
3329-808 Rev A