Assembling - Makita PC5001C Technical Information

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Armature, Spiral bevel gear 11
DISASSEMBLING
(2-S) If it is difficult to remove Armature by hand;
1) spray some lubricant to M7 Hex nut.
2) turn Armature with water pump pliers while holding M7 Hex nut with wrench 11.
Refer to Fig. 4-S.
Fig. 4-S
Spray some lubricant
to M7 Hex nut.
M7 Hex nut
Armature
(3) Retaining ring R-30, Flat washer 22, Ball bearing 6000DDW and Rubber ring 26 are still left in Gear housing.
They can be disassembled as illustrated in Fig. 5.
Fig. 5
Remove Retaining ring R-30 and Flat washer 22.
Retaining
ring R-30
Strike the edge of Gear housing with Plastic hammer.
Ball bearing 6000DDW and Rubber ring 26 come out together with
M7 Hex nut, Spiral bevel gear 11 and Armature.
Hold M7 Hex nut with wrench 11 and
turn Armature wrapped with cloth
clockwise using water pump pliers.
Wrench 11
Cloth to protect Armature
Flat washer 22
M7 Hex nut
Armature can be disassembled.
Pay attention not to lose M7 Hex nut and
Spiral bevel gear 11.
M7 Hex nut
Water pump
pliers
Secure Armature and Spiral bevel gear 11, and then
assemble them to Gear housing using M7 Hex nut.
Spiral bevel gear 11 functions as a tool for removing
Ball bearing 6000DDW at this time.
Spiral bevel gear 11
Rubber ring 26 Ball bearing 6000DDW
P 4/ 9
M7 Hex nut
Spiral bevel
gear 11
Armature
Wrench 11 for
holding M7 Hex nut
M7 Hex nut