Installing The Snowthrower On The Tractor - Toro 79366 Operator's Manual

2. Raise the attachment lift.
3. Set the parking brake, stop the engine, and remove the
ignition key.
4. Secure the lift arms to the tractor frame with two,
3/8 x 1 in. (25 mm) clevis pins and two small hairpin
cotters (Fig. 9).
Note: The two lift arms are located on the tractor
frame, just ahead of the rear wheels.
2
1
Figure 9
Right side of tractor shown
1. Lift arm
2. Clevis pin, 3/8 x 1 in.
(25 mm)
Important
Remove the pins when attaching a mower.
Installing the Snowthrower on
the Tractor
Connecting the Snowthrower to the Front
Attach-A-Matic Hitch
1. Position the snowthrower frame assembly and its
attachment parts on a level surface with enough space
behind them to accommodate the tractor.
2. Park the tractor behind the snowthrower with the front
wheels lined up to straddle the snowthrower frame and
lift rod (Fig. 10).
3
m–3433
3. Hairpin cotter, small
Figure 10
3. Lower the attachment lift, stop the engine, and remove
the ignition key.
4. With the high-low range selector in neutral (N), pull
the tractor forward toward the snowthrower until the
end of the snowthrower frame is just underneath the
tractor 's front Attach-A-Matic hitch (Fig. 11).
1
m–4344
Figure 11
1. Attach-A-Matic hitch
latches
5. Ensure the latches on the front Attach-A-Matic hitch
are open (Fig. 11).
6. Slide the pulley box completely into the hitch
(Fig. 11).
7. Close the latches by rotating them down (Fig. 11).
8. Install two C-pins into the locking holes of the pulley
box (Fig. 12).
9. Secure the pins with two small hairpin cotters on the
inside (Fig. 12).
8
m–3446
2
2. Pulley box