3
5
Figure 7
1. Idler pulley bracket
2. Bracket handle
3. Snowthrower housing
Installing the Guide Plate
1. Install the guide plate to the snowthrower pulley box
with 2 bolts (1/2 x 1–1/4 inch), 2 washers (1/2 inch) and
2 locknuts (1/2 inch) (Fig. 8).
1
2
3
Figure 8
1. Snowthrower pulley box
2. Guide plate
3. Bolt, 1/2 x 1–1/4 inch
2
4
1
m–7164
4. Shoulder bolt, 3/8 x
1–1/4 inch
5. Locknut, 3/8 inch
4
5
m–7165
4. Nut, 1/2 inch
5. Washer, 1/2 inch
Installing the Snowthrower to
the Tractor
Removing the Hood
If desired, remove the hood for better access to the upper
pulleys in the pulley box.
1. Rotate the hood fully forward (Fig. 9).
2. Disconnect the wire harness at the front left of the
machine. The harness leads up the to the head lights
(Fig. 9).
3. Slide the hood to the left side of the machine and off of
the pivot pegs (Fig. 9).
4
1
3
5
3
Figure 9
1. Hood—open position
2. Engine
3. Pivot peg
9
3
2
5
m–6647
4. Wire harness
5. Harness connector