Toro 79366 Operator's Manual page 18

Figure 37
Figure 38
1. Disengage the PTO, set the parking brake, lower the
attachment lift, stop the engine, and remove the key.
2. Clean the grease fittings with a rag.
3. Scrape any paint off the front of the fittings.
4. Connect a grease gun to each fitting in turn and pump
grease into them.
5. Wipe up any excess grease.
Oiling the Drive Chain and Discharge
Chute
1. Disengage the PTO, set the parking brake, lower the
attachment lift, stop the engine, and remove the key.
2. Coat the entire chain with oil and allow it to penetrate
each roller (Fig. 39).
m–3737
3. Place a few drops of oil on the discharge chute rotator
shaft and discharge chute mounting (Fig. 40).
m–3723
4. Wipe off excess oil.
Adding Gear Box Lubricant
1. Move the snowthrower to a level surface.
2. Disengage the PTO, set the parking brake, lower the
attachment lift, stop the engine, and remove the key.
3. Clean area around plug with a rag and remove plug
(Fig. 41).
18
Figure 39
Figure 40
m–3723
m–3732