Operation - Toro 79366 Operator's Manual

Disconnecting the Lift Rod
Disconnect the lift rod from the attachment lift plate by
removing the clevis clip and clevis pin (Fig. 30).
3
1
4
2
Figure 30
Right side of tractor shown
1. Middle hole in attachment
lift plate
2. Snowthrower lift rod
3. Clevis pin, 1/2 x 1 in.
(25 mm)
Disconnecting the Snowthrower
1. Press the button of the mid Attach-A-Matic hitch and
carefully turn the lever clockwise to release the
snowthrower (Fig. 31).
The snowthrower frame will drop to the ground.
Warning
The snowthrower is heavy and can injure hands
or feet if it falls on them.
Keep your hands and feet away from the
underside of the snowthrower frame.
3
2
1
Figure 31
Right side of tractor shown
1. Snowthrower frame
2. Mid Attach-A-Matic hitch
lever
5
2
m–3661
4. Clevis clip
5. Attachment lift plate
m–3707
3. Mid Attach-A-Matic hitch
button
14
2. Put the high-low range lever in neutral (N) and release
the parking brake.
3. Push the tractor back, away from the snowthrower
until there is sufficient space to remove the pulley box.
4. Remove the C-pins from the pulley box locking holes
(Fig. 32).
5. Open the latches of the front Attach-A-Matic hitch,
remove the pulley box, and slide it into snowthrower
frame.
6. Install the C-pins into the locking holes of the pulley
box for storage, securing them with the hairpin cotters.
1
3
Figure 32
1. Attach-A-Matic hitch
latches
7. Push the tractor back, away from the snowthrower
frame and set the parking brake.

Operation

Danger
If you attach the snowthrower to the tractor
without adding weight to the rear of the tractor,
the tractor may become unstable and could tip
over, crushing you or bystanders. You may also
lose control of the tractor.
Do not operate the snowthrower without first
installing rear wheel weights or a rear weight box.
2
m–4344
2. Pulley box
3. Locking holes