Toro 79366 Operator's Manual page 13

3
Figure 26
1. Engine PTO pulley
2. Snowthrower pulley
7. Replace the right side panel and close the hood.
Removing the Chute Crank
1. Remove the chute control rod by removing the hairpin
cotter connecting it to the universal joint (Fig. 27).
4
Figure 27
1. Chute control rod
2. Crank support
2. Slide the chute control rod out of the end of the crank
support (Fig. 27).
3. Remove the crank support by removing the hairpin
cotter and clevis pin at its base (Fig. 28), then lifting
the support from its mounting post.
1
2
4
m–3696d
3. Belt
4. Spring-loaded pulley
1
2
m–4349
3
3. Universal joint
4. Hairpin cotter, medium
13
4
Figure 28
Left side of tractor shown
1. Support brace assembly
2. Washer, 15/16 in. (24mm)
3. Hairpin cotter, large
Disconnecting the Rear of the
Snowthrower
1. Remove the support braces from the frame rods
protruding from the mid Attach-A-Matic hitch by
removing the hairpin cotters and washers (Fig. 28).
2. Remove the other ends of the two support braces from
the rear Attach-A-Matic hitch mount by removing the
hairpin cotters and washers (Fig. 29).
1
3
5
6
7
Figure 29
1. Support rod link
2. Rear Attach-A-Matic hitch
3. Front of tractor
4. Rear Attach-A-Matic hitch
latch
3. Release the latches on the rear Attach-A-Matic hitch
and remove the support rod link (Fig. 29).
1
3
2
m–3681
4. Mounting post for crank
support
4
2
m–3724
5. Support brace
6. Washer, 13/16 in. (21 mm)
7. Hairpin cotter, large