Toro 79366 Operator's Manual page 11

6. On the right side of the tractor, pull forward on the
spring tension lever and connect the spring tension link
to the keyhole slot in the snowthrower frame (Fig. 20).
1
Figure 20
Right side of tractor shown
1. Spring tension link
2. Spring tension lever
Securing the Rear of the Snowthrower
1. Open the latches on the rear Attach-A-Matic hitch.
2. Put the support rod link into the front notches on the
rear Attach-A-Matic hitch and close the latches to
secure it in place (Fig. 21).
1
3
5
6
7
Figure 21
1. Support rod link
2. Rear Attach-A-Matic hitch
3. Front of tractor
4. Rear Attach-A-Matic hitch
latch
3. Slide the non adjusting ends of the two support braces
onto the support rod link that is now in the rear
Attach-A-Matic hitch mount, ensuring that the rob on
each brace faces inward.
4. Secure the braces to the rod with a 13/16 in. (21 mm)
washer and a large hairpin cotter (Fig. 21).
4
2
m–4346
3
3. Snowthrower frame
4. Keyhole slot
4
2
m–3724
5. Support brace
6. Washer, 13/16 in. (21 mm)
7. Hairpin cotter, large
11
5. Secure the other ends of the support braces to the
frame rods protruding from the mid Attach-A-Matic
hitch with a 15/16 in. (24 mm) washer and a large
hairpin cotter (Fig. 22).
Note: You may need to turn the adjuster of each brace
before the holes in the adjuster align with the frame
rod.
4
Figure 22
Left side of tractor shown
1. Support brace
2. Washer, 15/16 in. (24mm)
3. Hairpin cotter, large
Installing the Chute Crank
1. Slide the crank support onto the mounting post on the
left-hand side of the tractor (Fig. 22).
2. Secure the crank support in position with a locking pin
and small hairpin cotter (Fig. 23).
Figure 23
Left side of tractor shown
1. Crank support
2. Locking pin
3. Slide the chute control rod through the hole in the end
of the crank support (Fig. 24).
1
3
2
m–3681
4. Mounting post for crank
support
1
2
3
m–4347
3. Hairpin cotter, small