Setting Up The Tractor - Toro 79366 Operator's Manual

2
Figure 5
1. Snowthrower belt
2. Slide the pulley box into the snowthrower frame
(Fig. 6).
3. Route the belt over the snowthrower pulley (Fig. 6).
4
3
5
1
Figure 6
1. Snowthrower frame
2. Snowthrower pulley
3. Pulley box
4. Ensure that the wide side of the PTO drive belt is
toward the outside diameter of all the pulleys (Fig. 7).
1
m–4348
2. Belt guide
2
m–4342
4. Lift tube
5. Belt guide
2
Ï Ï Ï Ï
Ï Ï Ï Ï
Ï Ï Ï Ï
Ï Ï Ï Ï
Figure 7
1. Pulley outside diameter
5. Attach the pulley cover to the snowthrower frame
assembly with four, #10 x 1/2 in. (13 mm) screws
(Fig. 8).
1
2
3
Figure 8
1. Pulley cover
2. Screw, #10 x 1/2 in.
(13 mm)

Setting Up the Tractor

Installing the Rear Attach-A-Matic Hitch,
Rear Wheel Weights, and Chains
Install the rear Attach-A-Matic hitch, the rear wheel
weights, and chains according to the instructions supplied
with them.
Note: If you will be using the snowthrower on slopes or in
very slippery conditions, purchase and install a rear
weight box instead of the rear wheel weights.
Preparing the Attachment Lift
1. Start the engine.
7
1
m–4230
2. Wide side of belt
m–4343
3. Snowthrower frame
assembly