Installing The Discharge Chute; Installing The Cable Guide; Installing The Snowthrower; Figure - Toro 22456 Operator's Manual

2

Installing the Discharge Chute

Parts needed for this procedure:
1 Snowthrower housing
1 Discharge-chute assembly
1 Deflector shield
3 Carriage bolt
3 Washer
3 Locknut
Procedure
Install the deflector shield and the discharge-chute assembly
onto the snowthrower housing with 3 carriage bolts (heads to
inside), 3 washers, and 3 locknuts
1
5
1. Discharge chute
2. Carriage bolt
3. Washer

(Figure

2).
2
3 4
G011829
Figure 2
4. Locknut
5. Deflector shield
3

Installing the Cable Guide

200/300 Series Traction Units
Parts needed for this procedure:
1 Cable guide
Procedure
1. If your traction unit has a bolt installed in the underside
of the loader-arm cross bar, between the right loader
arm and the hydraulic hoses, remove the bolt.
2. Place the cable guide over the loader-arm crossbar on
the far right side
1
5
1. Cable guide
2. Loader-arm crossbar
3. Clamp
3. Insert the clamp into the slot in the cable guide, then
secure it with a knob
8
(Figure 3).
2
4
3
G011830
Figure 3
4. Slot
5. Knob
(Figure 3).