Konftel 300IP Manual page 56

Detailed end point ivt test plan and report
Hide thumbs Also See for 300IP:
Table of Contents

Advertisement

7101 did not go on-hook when 7100 was disconnected. No SIP message to that
Test Case #
Objective
Pre-Test Conditions
Local CUCMDUT(s):7100 & 7101;SCCP:1000; SIP:2000;
Remote CUCMDUT:8000;
RPC is used to remotely control IP Phones with DN: 1000,2000;
Test Procedure
1. 7100 dials 71017101 answers
2. Remove power cable from 7101
3. Restore power cable after 60s
4. 2000 dials 71017101 answers call
5. 7101 goes on-hook after 60s
6. Retrieve CDR from CUCM
7. Check Calling, Called, Duration, Origination & Termination
Cause Codes
7100 did not go on-hook when 7101 was disconnected. No SIP message to that
Test Case #
Objective
Local CUCMDUT(s):7100 & 7101;SCCP:1000; SIP:2000;
Remote CUCMDUT:8000;
Invalid DN:7777
Call Waiting disabled for 7100 & 7100
Device Profile: Busy Trigger set to 1 for DN: 7100 & 7101
Voicemail disabled for 1000 & 2000;
RPC is used to remotely control IP Phones with DN: 1000,2000;
1. 7100 dials 10001000 answers
2. 7101 dials 7100
3. 7101 dials 1000
4. 7101 dials 2000 (RNA)
5. 7101 dials 7777 (Invalid DN)
6. 7101 dials 234-8000
7. 7101 goes on-hook before 8000 answers (Abandoned)
8. 7100 goes on-hook after 120 secs
9. Retrieve CDR from CUCM
10. Check Calling, Called, Duration, Origination & Termination
Cause Codes
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
extension. DUTs on PoE
EP-49
Category
Negative Test: Phone Power Failure
Verify DUT(s) recovers from a power failure
Test Results: Comments
extension. DUTs on PoE
EP-50
Category
Negative Test: Abnormal Call Scenarios
Verify calls on DUT for negative call scenarios (Invalid DN, Busy DN, Abandoned, RNA)
Test Procedure
Expected Results
Call establish between 7100 & 7101 with 2-way audio
7101 lost power
Stable call drops
Device 7101 re-registers after power is restored
Network Data: DNS, DHCP, TFTP, CUCM, VLAN, Load ID are
restored on device
Call establish between 2000 & 7101 with 2-way audio
Call terminate normally
2 CDR(s) retrieved
Selected fields in CDR(s) match calls
Pre-Test Conditions
Expected Results
Call establish between 7100 & 1000 with 2-way audio
7101 hears busy tone for calls to 7100 & 1000
7101 hears ring back timeout for call to 2000
7100 hears reorder tone when it dialed invalid DN:7777
1 Call terminated normally
5 unsuccessful call attempts
6 CDR(s) retrieved
Selected fields in CDR match calls
x
RFC_Standard
P
F
N/A
N/S
N/T
x
RFC_Standard
Page 56 of 64
Y
B
Y

Advertisement

Table of Contents
loading

Table of Contents