Test Case #
Objective
Pre-Test Conditions
•
Local CUCMDUT(s):7100 & 7101; SCCP:1000; SIP:2000;
•
Remote CUCM DUT:8000;
•
Call Park Code: RoutingCall Park3001
•
Service Parameter: Call Park Reversion Timer 60s
•
RPC is used to remotely control IP Phones with DN: 1000, 2000;
Test Procedure
1. 7100 dials 234-80008000 answers
2. 7100 hits "Park" softkey after 10s
3. Do not pickup parked call for 60s
4. 7100 is ringing7100 answers
5. 8000 goes on-hook after 30s
6. 7100 dials 10001000 answers
7. 1000 hits "Park" softkey after 10s
8. Do not pickup parked call for 60s
9. 1000 is ringing1000 answers
10. 7100 goes on-hook after 30s
11. 2000 dials 71017101 answers
12. 7101 hits "Park" softkey after 10s
13. Do not pickup parked call for 60s
14. 7101 is ringing7101 answers
15. 2000 goes on-hook after 30s
16. Retrieve CDR from CUCM
17. Check the Calling, Called, Duration, Origination & Termination
Cause Codes
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
EP-16
Category
Functional Test: Call Park Reversion
Verify "Call Park Reversion" call for DUT(s), SIP and SCCP endpoints
Test Results: Comments
No softkey on DUT
Expected Results
•
Call establish between 7100 & 8000 with 2-way audio
•
8000 is parked
•
7100 picks up parked call
•
Call establish between 7100 & 8000 with 2-way audio
•
Call terminate normally
•
Call establish between 7100 & 1000 with 2-way audio
•
7100 is parked
•
1000 picks up parked call
•
Call establish between 1000 & 7100 with 2-way audio
•
Call terminate normally
•
Call establish between 2000 & 7101 with 2-way audio
•
2000 is parked
•
7101 picks up parked call
•
Call establish between 7101 & 2000 with 2-way audio
•
Call terminate normally
•
6 CDR(s) retrieved
•
Selected fields in CDR match calls
P
RFC_Standard
N
F
N/A
N/S
N/T
B
x
Page 27 of 64