Installation Tests - Konftel 300IP Manual

Detailed end point ivt test plan and report
Hide thumbs Also See for 300IP:
Table of Contents

Advertisement

Run "Step 2_Record_Connectivity_Validation" command after verifying the endpoints are
9.2
Integration Test
Test is focused on ensuring that the 3
Test Case #
Objective
Enable auto-registration in Local CUCM with DN range 7100 – 7199
Local CUCM ClusterNPA-NXX 410-444-XXXX
Remote CUCM ClusterNPA-NXX322-234-XXXX
CUCM Administration GUI:
Hardware VPN Router setup to EP_IVT Lab
1. Connect two DUT(s) in local CUCM cluster
2. Connect one DUT in remote CUCM cluster
3. Run "Step1_Endpoint Registration" cmd to register DUT(s)
4. Run "Utility_Device_Status" cmd to check registration status
5. Go off-hook on DUT(s) to check for dial tone
6. Go to DUT(s) settings to verify network and load information
7. In local CUCM cluster, change DN of DUT(s) to 7100 & 7101
with device poolep_pool
8. In remote CUCM cluster, change DN of DUT to 8000
9. Assign all DUT(s) a softkey template of "SIP_EP_User"
10. Associate end users to DUT(s) as follows:
DevicePhoneLineAssociate End Users
DUT:7100dutuser01
DUT:7101dutuser02
DUT:8000rdutuser01
Note:
Endpoint Registration command is setup to register endpoints to
local CUCM Cluster
To register endpoints to remote CUCM cluster, manually enter the
TFTP IP address of remote CUCM to DUT
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Run "Step 1_Endpoint_Registration" command to register endpoints.
registered with the correct network and load information.
rd
party product (DUT) is registered with Call Manager successfully
EP-1
Category
ConnectValidate
rd
Verify 3
party endpoints (DUT) are registered in Call Manager successfully
https://X.X.X.X:8443
Test Procedure
Test Results: Comments
Pre-Test Conditions
(X.X.X.X= CUCM-PUB IP)
Expected Results
DUT(s) goes through CUCM auto-registration process
CUCM Administration .GUI display the DUT(s)
DUT(s) are in "Registered" state
DUT(s) have a DN assigned
Dial tone played when phone goes off-hook
DUT(s) network data is correct:
(VLAN, DNS, DHCP, TFTP, CUCM)
DUT(s) Phone Load version is correct
DUT(s) DN changed to proceed with test cases
DUT(s) softkey template updated to "SIP_EP_User"
Users associated to DUT(s) respectively
RFC_Standard
P
F
N/A
N/S
N/T
X
Page 14 of 64
Y
B

Advertisement

Table of Contents
loading

Table of Contents