Miele CM6x10 Operating Instructions Manual page 71

Problem
Empty the drip tray and the
waste container appears
in the display, even
though the drip tray has
been emptied.
Insert the drip tray and the
appears
waste container
in the display even
though both are fitted.
The drip tray or waste
container is full or
overflowing, although
they have been emptied
following each
reminder.
Fill the bean
container appears in the
display even though the
bean container has just
been filled.
The coffee machine
does not rinse itself
when turned on.
Cause and remedy
The drip tray is not positioned correctly in the
machine.
 Push the drip tray in as far as it will go.
 Make sure that the lower panel is sitting on the
drip tray correctly.
The drip tray is not in the correct position and is
therefore not detected.
 Empty the drip tray and the waster container.
Reassemble all parts and push the drip tray back
in the coffee machine until it clicks into position.
The machine is open.
 Close the machine.
 If necessary, empty the drip tray and the waste
container. Reassemble all parts and push the drip
tray back in the coffee machine until it clicks into
position.
This is not a fault.
The drip tray and waste container were probably
removed or the machine was opened without the drip
tray and waste container being emptied. When the
drip tray is removed or the machine opened, the
internal counter for emptying the drip tray and waste
container is automatically reset.
 Remove the drip tray and waste container from the
machine and empty them.
This is not a fault.
 Confirm the message with OK.
This is not a fault.
If the coffee machine still has an operating
temperature higher than 60 °C, rinsing will not take
place.
Problem solving guide
71