Clutch Lever Sensor - MOTO GUZZI V7 Stone Servise Manual

V7 Stone - V7 Special - V7 Racer
Restore if damaged.
•
If OK, check continuity.
•
If there is no continuity, restore the cabling.
•
If OK, replace the instrument panel if the vehicle performs properly.
•
NEUTRAL Warning light always on
Troubleshooting
Disconnect the terminals from the sensor and verify that, with the transmission in gear, there
•
is continuity with the ground.
If there is continuity, replace the sensor.
•
If there is no continuity this means that there is a short to ground of the green black cable
•
which goes to PIN 3 of the control unit, therefore restore the cabling.
If the error persists, disconnect the terminals from control unit PIN 17 to instrument panel
•
PIN 10 and verify continuity.
If there is no continuity, restore the cabling.
•
If there is no continuity, replace the cabling.
•

Clutch lever sensor

Function
It tells the clutch lever position to the control unit.
Operation / Operating principle
In order to start the engine, pull the clutch also with
the gear in neutral.
Level in electrical circuit diagram:Start-up ena-
bling switches.
Location:
sensor: under clutch lever
•
connector: under the fuel tank on right
•
side
Electrical characteristics:
Clutch pulled: closed circuit (continui-
•
ty)
Clutch released: open circuit (infinite
•
resistance)
Pin-out:
1. 12 V Voltage (brown white cable)
2. Ground (blue black cable)
Even with the clutch lever pulled, the vehicle does not start
Electrical system
ELE SYS - 101