Connecting The Cable - Epson TM-C3400-LT Technical Reference Manual

Connecting the Cable

To access to the rear connectors, you need to remove the rear cover.
Open the fanfold paper cover (1), loosen the two screws (2), and then remove the rear cover (3). After
connecting the cable, be sure to re-install the rear cover.
 Never disconnect the cables initially connected to the USB connectors on the right.
 When connecting USB devices to the USB connector, be sure to pass the cable through
the groove (1), hook the cable holder (2), pull it out from the bottom of the rear cover (3),
and then reattach the rear cover. 
The cable holder prevents the cables from piling on each other. If the power cord or
other cables are piled on each other, the rear cover cannot be attached.
Cable holder
Chapter 2 Setup
Groove
37
2