Safety Precautions
TM-C3400Z User's Manual presents important information intended to ensure safe and effective use of this
product. Please read it carefully in advance. TM-C3400Z User's Manual is included on the TM-C3400Z
Documents Disc.
1
Unpacking
If any items are damaged, contact your dealer.
Label paper roll
TM-C3400Z printer
Ink cartridge
(Model: SJIC15P)
Paper ejection tray
2
Installation
WARNING:
Do not block the air vents on this product. Blocking the air vents may result in internal heat build-up and fire.
CAUTION:
・Install the product horizontally on a flat, stable, and vibrationfree surface.
Otherwise, the roll paper cover may not operate correctly, and your fingers may be caught.
・Do not tilt the product with the roll paper cover open. The roll paper cover may close
unexpectedly, and your fingers may be caught.
・When carrying the product, be sure to hold the parts as shown in the picture below.
If you install the product against a wall, keep the product more than 10 cm from the wall.
Leave enough space for the roll paper cover, ink cartridge cover,
・
and fanfold paper cover to be fully opened.
・Protect the product from heavy impacts. They may cause defective print.
・Do not allow cables to catch or foreign matter to accumulate under the product.
Setup Guide
Documents Disc
TM-C3400Z
Warranty card
Setup Guide
Air vents
10cm
10cm
3.93in
3.93in
3
Connecting Cables
1
Remove the rear cover.
2
AC cable
Connect the USB cable.
Connect the LAN cable.
3
WARNING:
Be sure to use the AC cable that is included with the product, and ground it.
Be sure to use the specified power supply.
Do not turn on the power before Installing the Paper.
Connect the AC cable.
CAUTION:
Never disconnect the cables initially connected to the USB connectors on the right.
If the power cord or other cables are piled on each other, the rear cover cannot
be attached.
Note:
If setting the printer, connect the LAN cable.
If printing, connect the LAN cable or the USB cable.
Be sure to pass the cable through the groove (①), hook the cable
holder (②), pull it out from the bottom of the rear cover (③), and then
reattach the rear cover.
Be sure to pass the cable through the groove (①), hook the cable
holder (②), pull it out from the bottom of the rear cover (③), and then
reattach the rear cover.
Be sure to pass the cable through the groove
Connect the power plug to the wall
(①), hook the cable holder (②), pull it out from
outlet.
the bottom of the rear cover (③), and then
reattach the rear cover.