Table of Contents
Advertisement
[Maintenance And Utilities] tab
Make the following settings to the printer.
Post-Printing Verification Settings
Changes settings of operation, registration of invalid images to the documents, test printing of invalid
images at missing dots.
Following are the modes for operation setting when Post-Printing Verification Settings.
• Anti-missing Color Mode:
• Anti-missing Read Mode:
• High Reliability Mode (Reprint) / Economy Mode for Low Print Volume (Reprint):
• High Reliability Mode (Void Image Reprint) / Economy Mode for Low Print Volume (Void Image Print):
The button for [High reliability mode (Void Image Test Print)] or [Economy Mode for Low
Print Volume (Void Image Print)] on [Driver Preferences] is grayed out when [Use
EPSON Status Monitor 3] on [Driver Preferences] of [Driver Utilities] is not selected.
The dots may be missing due to mis-reading when "Anti-missing Color Mode" is
selected. It is recommended to use "Anti-missing Read Mode" or "High Reliability Mode"
to avoid such dot missing from mis-reading.
Notification Settings
Makes settings of the buzzer on/off, the printer status utility notification at the ink low status and the
paper type error notification when such error occurs.
Panel Button Settings
Among the panel buttons on the printer, enable/disable the FEED button and the CUT button.
Media position detection
Changes the media position detection setting based on the type of paper.
The paper error occurs when the printer setting is not matched with the paper type and
printing can not be performed. See
this adjustment.
Media Loading Settings
Changes settings of the paper set operation and auto-cut function when powering on and closing the
cover.
Executes cleaning when two or more dots are missing side
by side in the paper feed direction, or three or more dots are
missing arbitrarily.
Executes a head cleaning when any dot is missing.
When dot missing occurs, the EPSON Status Monitor 3 is dis-
played. Select the next operation from [Restart printing]
(printing the next data) and [Reprint] (reprinting after dot
missing is resolved by the auto head cleaning.)
Prints the image that indicates dot missing and reprints the
same data when any dot is missing. Cuts and prints the top
of the void images if the paper height is less than one inch.
"Replacing the Paper" on page 139
Chapter 5 Setting the Printer Driver
for details about
5
97
Advertisement
Table of Contents
