Setup; Mounting The Debris Blower To The Traction Unit - Toro 08759 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
Debris blower assembly
2
No parts required
3
No parts required
Parts catalog
4
Installation instructions
Note: Determine the left and right sides of the
machine from the normal operating position.
Note: To operate the debris blower, the traction
unit must be equipped with the Rear Remote
Hydraulics Kit, Model 08781.
Step
1
Mounting the Debris Blower
to the Traction Unit
Parts needed for this step:
1
Debris blower assembly
Procedure
1. Remove any attachment from the rear of the
machine.
2. Back the traction unit into position behind the
attachment adapter.
Note: Make sure the locking lever (Figure 3)
is pivoted to the left (unlocked position) as
viewed from the rear of the machine.
3. Raise the traction unit adapter into the
attachment adapter.
Description
4. Pivot the locking lever to the right to lock the
5. Connect the attachment hydraulic hose
1. Attachment adapter
6
Qty.
Mount the debris blower to the
1
traction unit
–
Adjust the link assembly
–
Grease the blower
1
Finish the setup.
1
adapters together.
couplers to the hydraulic couplers on the
traction unit rear remote hydraulics kit.
Important: Whenever the hydraulic
hose couplers are disconnected, make
sure the dust plugs are installed to prevent
contamination from entering either
hydraulic system.
2
G003810
Figure 3
2. Locking lever
Use
1