Table of Contents
Advertisement
Step
2
Adjusting the Link Assembly
No Parts Required
Procedure
1. With the debris blower mounted and secured
on the traction unit, raise the attachment.
2. Measure the gap between the top washer
and the spacer in the link assembly on the
attachment adapter as shown in Figure 4.
Note: The gap between the washer and the
shoulder should be 0.060 to 0.080 inch
2
3
1
G003811
Figure 4
1. 0.060 to 0.080 inch
2. Jam nut
3. Adjustment nut
Step
3
Grease the Blower
No Parts Required
Procedure
Before the Debris Blower is operated, it must be
greased to assure proper lubrication. Refer to
Lubrication section of manual. Failure to properly
grease the unit will result in premature failure of
critical parts.
Step
4
Finishing the Setup
Parts needed for this step:
1
Parts catalog
1
Installation instructions
Procedure
Review the following material and save in an
appropriate place:
• Parts Catalog
• Installation Instructions
7
Advertisement
Table of Contents
