Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Toro 08759
Summary of Contents for Toro 08759
- Page 1 Form No. 3364-397 Rev A Debris Blower Sand Pro/Infield Pro 3040 and 5040 Traction Unit Model No. 08759—Serial No. 310000001 and Up To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com. Original Instructions (EN)
-
Page 2: Table Of Contents
Whenever you need service, genuine Toro parts, or While Operating........... 3 additional information, contact an Authorized Service Maintenance............3 Dealer or Toro Customer Service and have the model Safety and Instructional Decals ......4 and serial numbers of your product ready. Figure 1 Setup................6... -
Page 3: Safety
Model and Serial Number – Watch out for traffic when near or crossing to The Toro® Company, 8111 Lyndale Avenue roads. Always yield the right-of-way. South, Bloomington, Minnesota 55420-1196. -
Page 4: Safety And Instructional Decals
Use cardboard or paper to find hydraulic purchase genuine Toro replacement parts and leaks. Hydraulic fluid escaping under pressure can accessories to keep the machine all Toro. Never penetrate skin and cause injury. Fluid accidentally use “will-fit” replacement parts and accessories injected into the skin must be surgically removed made by other manufacturers. - Page 5 106-5517 1. Warning—do not touch the hot surface. 105-4593 1. Entanglement hazard, shaft—do not remove cover while parts are moving, keep all guards in place.
-
Page 6: Setup
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Mount the debris blower to the traction Debris blower assembly unit – No parts required Adjust the link assembly – No parts required Grease the blower Media and Additional Parts Description... -
Page 7: Adjusting The Link Assembly
4. Pivot the locking lever to the right to lock the adapters together. 5. Connect the attachment hydraulic hose couplers to the hydraulic couplers on the traction unit rear Grease the Blower remote hydraulics kit. Important: Whenever the hydraulic hose No Parts Required couplers are disconnected, make sure the dust plugs are installed to prevent contamination... -
Page 8: Product Overview
A selection of Toro approved attachments and accessories are available for use with the machine to enhance and expand its capabilities. Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for a list of all approved attachments and accessories. G003812 Figure 5 1. - Page 9 G003783 Figure 6 1. Pry slot...
-
Page 10: Maintenance
Maintenance Bearing Alignment If the motor mounting brackets are ever removed, they Lubrication must be realigned before the debris blower is operated. Refer to the Part Catalog for the Alignment Tool part The debris blower has (2) fan shaft bearings that must number. -
Page 11: Torquing Fasteners
Torquing Fasteners If the blower is ever disassembled, the following fasteners must be torqued as specified. Also, apply Loctite 242 to the threads before installing. • The set screws securing the motor and fan shaft couplers (Figure 10) must be torqued to 58 to 82 in-lb. - Page 12 Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfied with your Distributor’s service or have difficulty obtaining guarantee information, contact the Toro importer.