Related Manuals for Toro 08759
Summary of Contents for Toro 08759
- Page 1 Form No. 3354-277 Rev C Debris Blower For Sand Pro® 3040 & 5040 Model No. 08759—Serial No. 260000001 and Up Register your product at www.Toro.com Original Instructions (EN)
-
Page 2: Table Of Contents
Whenever you need service, genuine Toro parts, or Maintenance ..........3 additional information, contact an Authorized Service Sound Pressure ..........4 Dealer or Toro Customer Service and have the model Sound Power ..........4 and serial numbers of your product ready. Figure 1 Vibration............4 identifies the location of the model and serial numbers... -
Page 3: Safety
– Reduce your speed when making sharp complete Model and Serial Number to The turns and when turning on hillsides. Toro® Company, 8111 Lyndale Avenue South, Bloomington, Minnesota 55420-1196. – Avoid sudden starts and stops. • Never allow children to operate the machine. -
Page 4: Sound Pressure
• Do not overspeed the engine by changing the governor settings. To be sure of safety and accuracy, have an Authorized Toro Distributor check the maximum engine speed with a tachometer. • The engine must be shut off before checking the oil or adding oil to the crankcase. -
Page 5: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 106-5517 1. Warning—do not touch the hot surface. 98-3110 1. -
Page 6: Setup
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Step Description Qty. Mount the debris blower to the Debris blower assembly traction unit – No parts required Adjust the link assembly – No parts required Grease the blower Parts catalog Finish the setup. -
Page 7: Adjusting The Link Assembly
Step Step Adjusting the Link Assembly Grease the Blower No Parts Required No Parts Required Procedure Procedure 1. With the debris blower mounted and secured Before the Debris Blower is operated, it must be on the traction unit, raise the attachment. greased to assure proper lubrication. -
Page 8: Operation
Operation Note: If the attachment adapter becomes stuck to the traction unit adapter, insert a prybar/screwdriver into the pry slot to disengage Adjust Discharge Opening the parts (Figure 6). The discharge opening (Figure 5) is adjustable to increase or decrease air output velocity and volume. -
Page 9: Maintenance
Maintenance Lubrication The debris blower has (2) fan shaft bearings that must be lubricated regularly. The bearings are located on each side of the blower housing. If the machine is operated under normal conditions, lubricate bearings with No. 2 general purpose lithium base grease after every 8 hours of operation or daily, whichever comes first. -
Page 10: Torquing Fasteners
G003815 G003816 Figure 10 Figure 11 1. Motor coupler 3. Set screw (2 each) 2. Fan coupler 4. Coupler spider 1. Set screw 3. Tighten the capscrews and nuts securing the • The fan mounting nut (Figure 12) must be mounting brackets together and to the blower torqued to 500 ft–lb. - Page 12 (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatised with your Distributor’s service or have difculty obtaining guarantee information, contact the Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company.