Maintenance - Montigo C38-VF Installation Operation & Maintenance

Vent free gas fireplace
Hide thumbs Also See for C38-VF:
Table of Contents

Advertisement

C38-VF Gas Fireplace
Operating Instructions
Lighting Instructions
See page 7.
Burner Adjustment
The C38-VF is equipped with an adjustable burner, allowing you to
raise or lower the flames. To adjust the flames, locate the black knob
marked 'Hi-Lo', in the centre of the gas control valve (See Figure 10).
The front burners are not adjustable.
To raise the flame height, turn the black knob (located behind the
lower trim) counterclockwise.
To lower the flame height, turn clockwise.
Figure 10. 'Hi-Lo' Adjustment on the C38-VF's gas valve.
Page 8

Maintenance

CAUTIONS
Fireplace gas control must be in the "OFF" position and
pilot and main burners extinguished when cleaning
appliance with a vacuum.
Doors and logs can get very hot. Handle only when cool.
General
Have the fireplace installation inspected yearly, including a visual
check of the burner and the pilot flame. For your convenience a 1/8"
manifold pressure tap is supplied on the gas valve for a test gauge
connection. See Figure 11.
For Natural Gas this appliance requires a minimum inlet pressure of
5.5" W.C. and a manifold pressure of 3.5" W.C.
For Propane Gas this appliance requires a minimum inlet pressure
of 11" W.C. and a manifold pressure of 10" W.C.
Always keep the fireplace area clear and free of combustible
materials, as well as gasoline and other flammable vapours and
liquids.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control
which has been under water.
Cleaning
When the fireplace is first activated, there may be some smoking. This is
a normal condition, and is the result of burning of protective coatings on
new metal.
Silicone seals on inner door during initial firing will "off gas", leaving a
visual deposit of a white substance on combustion chamber walls.
This can easily be removed using normal household products.
Use a vacuum cleaner or whisk broom to keep the control
compartment, burner, and firebox free from dust and lint.
Logs may be cleaned periodically with a vacuum to remove soot or
other contaminates.
WARNING:
Do not attempt to clean the fireplace when hot.
Part No. XG0317

Advertisement

Table of Contents
loading

Table of Contents