Chapter 9. Fault Detection; The Dryer Does Not Start - Haier HD80-26A Service Manual

Service Manual
Model No: 26A SERIES
Chapter 9. Fault Detection
9-1

The dryer does not start

The power supply plug peels off;
N
The local circuit is out of power;
N
T he door is not closed tightly;
N
The power button is OFF
N
The Start/Pause button has not
been pressed
N
The envirment temperature is
too low;
N
Check if the PCB is failed.
N
The water tank is full;
Insert the power plug into an
appropriate receptacle and
Y
turn on the power
Put on the local circuit
Y
Y Close the door
Y Press on the power button
The Start/Pause button has
Y
not been pressed;
Use the dryer when enviroment
temperature is higher than 2 .
Y
Y Change PCB.
Y
Empty the tank
-29 -
Issue
Rev.
tightly