Service Manual
Model No: 26A SERIES
9-5
Code:F33
Error message:The NTC3(near the outlet of compressor) is short or cut out;
Check if the connector are
inserted properly
N
Check if NTC is failed ;
N
Check if the PCB is failed ;
Code:F4
9-6
Error rmessage:Temperature of the laundry in the drum does not change.
Check if the Refrigerant let out.
N
Check if the compressor is failed ;
9-7
Code:E6
Error rmessage:The filters is clogged.
Check if the filter is full with
N
Check if the humidity sensor have
short circuit.
9-8
Code:E7
Error message: Under voltage or overvoltage fault.
SOLUTION: Check the voltage of power suply.
Code:E8
9-9
Error message:Over load warning.
SOLUTION: Reduce the load,Repower the dryer.
Code:Lo
9-10
Error message:Temperature is too low.
SOLUTION: Use the dryer when air temperature is higher than 2 degree.
Code:F9
9-11
Error message:The motor communication fails.
SOLUTION : Check the communication wire .Be sure it is connected well.
Lints
-32 -
Issue
Rev.
Inserte the connector
Y
properly.
Y
Replace a new NTC;
Replace a new PCB.
Y
Charge the Refrigerant
Y
again
Replace a new base
Y
assembly
Clean the filter.
Y
Y
Change humidity sensor