Table of Contents
Advertisement
English
5. OPERATING MODES
5.7.3 Parameter Settings
Closed loop process control cannot be used unless P201 is first set to 001. Most of the parameters associated with closed loop process
control are shown in Figure 5.7.1. Other parameters which are also associated with closed loop process control are as follows:
P010 (only if P001 = 1, 4, 5, 7 or 9)
P061 (value = 012 or 013)
P220
Descriptions of all closed loop process control parameters are provided in section 6. For detailed information about PID operation, refer
to the application note "Closed Loop Control", which may be obtained from
or a Siemens sales office.
http://www.siemens.com/micromaster
G85139-H1751-U529-D1
© Siemens plc 1999
4/8/99
40
Hide quick links:
Advertisement
Table of Contents
