Appendix 4 Troubleshooting - Toshiba TOSVERT VF-nC3 Instruction Manual

efesotomasyon.com -Toshiba inverter,drive,servo,plc

Appendix 4 Troubleshooting

If a problem arises, diagnose it in accordance with the following table before making a service call.
If the problem cannot be solved by any remedy described in the table or if no remedy to the problem
is specified in the table, contact your Toshiba dealer.
Problem
Communication will not
place.
An error code is returned.
The trip err5 and alarm t
occur.
Frequency instructions from the
computer have no effect.
Commands, including the run
and stop commands, from the
commuter have no effect.
A change to a parameter does
not take effect.
The setting of a parameter was
changed, but it returns to its
original setting when the inverter
is turned off.
take - Are both the computer and the inverter turned on?
- Are all cables connected correctly and securely?
- Are the same baud rate, parity and bit length set for every unit on the
network?
- Is the data transmission format correct?
- Does the data written fall within the specified range?
- Some parameters cannot be written during inverter operation.
Changing should be attempted when the inverter is in halt.
- F700(Parameter write protect selection) is 2:RS485 communicatio
n inhibit
- If F738(Password setting) was set to data, F738 can not set to data.
- Check the cable connection and the timer setting.
- Is the frequency setting mode selection parameter set to "computer"?
- Is the command mode selection parameter set to "computer"?
Some communication-related parameters do not take effect until the
inverter is reset. To make them take effect, turn the inverter off tempo-
rarily, then turn it back on.
When using the TOSHIBA Inverter Protocol, use the W command to
write data into the EEPROM. If you use the P command that writes
data into the RAM only, the data will be cleared when the inverters are
reset.
Remedies
64
E6581657
Reference
Chapter 6
Section 4.1
Section 5.1
Chapter 8
Inverter
instruction
manual
Section 6.3
Section 7.1
Section 7.1
Chapter 6
Section 4.2