Toshiba TOSVERT VF-nC3 Instruction Manual page 49

efesotomasyon.com -Toshiba inverter,drive,servo,plc
Output terminal board status (FD07, FE07)
Output terminal board status (current status): "Communication Number FD07"
Output terminal board status (status immediately before the occurrence of a trip): "Communication
Number FE07"
Using terminal function selection parameters, functions can be assigned individually to the terminals
on the output terminal board.
When using a terminal as a monitoring terminal, check beforehand the function assigned to each
terminal.
Data composition of output terminal board status (FD07, FE07)
Bit Terminal name
0 OUT
1 (Reserved)
2 FL
3 to 15
Example: Data set for FE07 when both the OUT1 and FL terminals are ON = 0005H
FE07:
Monitoring of the analog input with the computer (FE35)
VI terminal board monitor: "Communication Number FE35FE36"
These monitors can also be used as A/D converters irrespective of the inverter's control.
VI terminal board monitor is capable of reading the data from external devices in a range of 0.01 to
100.00% (unsigned data: 0H to 2710H).
If analog input mode is selected with the frequency setting mode selection parameter, however,
keep in mind that any data entered via an analog terminal is regarded as a frequency command.
Function (parameter title)
Output terminal function selection 1 ( f130 )
---
Output terminal function selection 3 ( f132 )
－
BIT15
0 0 0 0 0 0 0
0 0
48
－
bit0
0 0 0 0 0 0 1 0
5
0
E6581657
0 1
OFF ON
--- ---
OFF ON
－ －
1