Table of Contents
Advertisement
MAINTENANCE:
This R100C has been engineered and built to require
minimum maintenance. But like any machine, it does
require some care to keep it in optimum working condi-
tion. Careful attention to these maintenance instructions
will give you maximum operating performance and life
expectancy of the machine.
CAUTION: Disconnect the power cord from the outlet
before doing any clean up or maintenance on the ma-
chine
1. Keep the machine clean. Do not allow dust to accu-
mulate on external surfaces or near any moving parts.
2. After every job, wipe down the surface of the machine
with a clean damp cloth.
3. Inspect cord for damage. Do not use machine with a
damaged cord.
PERIODIC MAINTENANCE
•
Use only chemicals safe for extractors
•
Adhere to the appropriate mix ratios for all chemicals
•
For optimal performance, it is suggested that the
operator flush the system after every job or at the end
of the day.
•
Pump seals and valves may need to be replaced at the
1000 hour mark if a loss in pressure is noted
Daily:
1. Always keep the machine clean inside and out.
2. Pour 2 gallons of clean hot water in the solution
tank. Turn the pump on and flush the entire system
through the wand nozzles for about a minute to pre-
vent alkaline build-up.
3. Remove dirt and lint build-up inside the filter screen
in the recovery tank. Lint should be cleaned off so
that air flow is not impeded.
4. Check the solution tank strainer in the solution tank.
If lint has accumulated in the screen, remove and
rinse it in clear running water.
Weekly:
•
Check and clean solution filter
•
Check for obstructions in vacuum pathways
•
Quarterly:
•
Check pump, plumbing and fittings for leaks
•
Check power cords and hoses for tears
CORD STORAGE:
While not in use, storage can be accomplished by wind-
ing cord around handle assy. Cord should be
completely unwound during operation.
CORD SAFETY
•
Do not leave appliance when plugged in. Unplug
from outlet when not in use and before servicing
•
Do not use with damaged cord or plug. If appliance is
not working as it should, has been dropped, damaged,
left outdoors, or dropped into water, return to service
center for inspection and repair.
•
Do not pull or carry by cord, use cord as handle, close
a door on cord, or pull cord around sharp edges or
corners. Do not run this R100C over cord. Keep cord
away from heated surfaces.
•
Do not unplug by pulling cord. To unplug, grasp the
plug, not the cord.
•
Do not handle plug or appliance with wet hands.
•
This equipment should be stored indoors and not
exposed to rain.
5
Advertisement
Table of Contents
