Table of Contents
Advertisement
Chapter 2 Installation and Connection
Prepare this instrument and compatible equipment
(shown in the "System Chart" on page 29 in
"Appendix") before each use, and refer to the instruction
manuals of each system component. Install and connect
the equipment as follows:
In addition, this "INSTRUCTIONS (BASIC)" explains
the EVIS EXERA video system center (CV-160) and the
VISERA video system center (OTV-S7V). For other
equipment, refer to "Chapter 2 Installation and
Connection" in "INSTRUCTIONS (ADVANCED)."
WARNING
• Review this chapter thoroughly before each use. If the
equipment is not properly prepared before each use,
equipment damage, patient and operator injury and/or
fire can occur.
• When non-medical electrical ancillary equipment is
used, connect its power cord via an isolation
transformer prior to connecting it to this video system
center. Failure to do so can cause electric shock, burns
and/or fire.
• Use this instrument and the color printing pack (UPC-
55) under the conditions described in "Operating and
Storage Environment" on page 31 and
"Specifications" on page 31 in "Appendix".
Otherwise, improper performance, compromised
safety and/or equipment damage may result.
• Connect the power cord to a wall mains socket outlet
and connecting cables to each equipment firmly. If do
not connect correctly, fire or electric shock may result.
CAUTION
• Turn OFF all equipments before connecting them.
Otherwise, equipment damage or malfunction may
result.
• Use appropriate cables. Otherwise, equipment
damage or malfunction may result.
• The cables should not be sharply bent, pulled, twisted
or crushed.
• When you connect another piece of video equipment
between this instrument and the video system center,
be sure not to turn off the power of the video
equipment while this instrument is being used. If you
turn off the power of the video equipment, the video
signal may not be input to this instrument properly,
and this instrument may not work correctly, depending
on the video equipment connected.
2.1 Installation of the
Color Video Printer
(OEP-4)
CAUTION
• Do not place any object on the top of this instrument.
Otherwise, equipment damage may result.
• Keep the ventilation grilles of this instrument clear.
Blockage may cause overheating and equipment
damage.
• Place this instrument on a stable and level surface.
Otherwise, this instrument topple down or drop.
• If a trolley other than the mobile workstation (WM-
N60) is used, confirm that the trolley can withstand the
weight of the equipment installed on it.
• This instrument cannot be used in every length.
Unstable operation, damage and/or abnormal printing
may result.
• Do not install this instrument near a source of strong
magnetic wave (microwave treatment device, short
wave treatment device, MRI, radio equipment, etc.).
Otherwise, this instrument may cause malfunction.
2.1 Installation of the Color Video Printer (OEP-4)
2
9
Hide quick links:
Advertisement
Table of Contents
