Table of Contents
Advertisement
Chapter 3 Inspection Before Use
WARNING
Before each case, inspect this instrument as instructed
below. Inspect other equipment to be used with this
instrument as instructed in their respective instruction
manuals. Should the slightest irregularity be suspected,
do not use this instrument and see "Chapter 7
Troubleshooting" in "INSTRUCTIONS
(ADVANCED)." If the irregularity is still suspected
after consulting Chapter 7 in "INSTRUCTIONS
(ADVANCED)," contact Olympus.
Damage or irregularity may compromise patient or user
safety and may result in more severe equipment damage.
3
Prepare this instrument and other equipment (shown in
"System Chart" on page 29 in the "Appendix") to be
used with this instrument for each particular case. Refer
to the respective instruction manual for each piece of
ancillary equipment.
14
3.1 Inspection of the Power Supply
3.1 Inspection of the
Power Supply
1
Press the power switch to turn ON the color video
printer (OEP-4) (see Figure 3.1).
2
Confirm that the PRINT lamp is lit and then turns
off (see Figure 3.1).
3
Press the power switch again.
4
Confirm that the LCD panel turns off.
PRINT lamp
LCD panel
Power switch
Figure 3.1
If the power fails to come on
If the power fails to come on, inspect according to
"Chapter 7 Troubleshooting" in "INSTRUCTIONS
(ADVANCED)."
When a power supply still is not tuned ON, contact
Olympus.
Hide quick links:
Advertisement
Table of Contents
