Connection To The Ac Mains Power Supply - Olympus oep-4 Instructions Manual

2.4 Connection to the
AC Mains Power
Supply
DANGER
Always power this instrument from a wall mains socket
outlet that has an exclusive terminal for grounding this
instrument. Otherwise, fire or electric shock may result.
WARNING
• Strictly observe the following precautions for the
power cord. Damaging the power cord may result in
fire or an electric shock:
Moreover, if power cord is damaged, turn OFF the
power and stop using this instrument immediately and
contact Olympus.
– When placing the power cord, take care that it is not
crushed in the space between this instrument and a
wall, mobile workstation or a shelf.
– Do not modify or damage the power cord.
– Do not use damaged power cord.
– Do not stretch or place a heavy object on the power
cord.
– Do not place the power cord near heating equipment
or expose it to excessive heat.
– Always grasp and pull the plug when unplugging the
power cord. Do not pull on the cord itself.
• Always use this instrument with the voltage specified
in "Specifications" on page 31 in "Appendix".
Supplying a non-specified voltage, fire and/or electric
shock may result.
• When there are metal and/or dust on power cord plug
or near the plug of the power cord, disconnect the
power cord and remove them with the dry cloth. If it is
then used, fire and/or electric shock may result.
• Always use the power cord and connection cables that
were shipped with this instrument or mobile
workstation. Using other power cords or connection
cables, electric shock and/or malfunction may result.
• Do not allow the power plug to become wet. Also do
not hold the power cord with a wet hand. A wet power
plug may cause electric shock.
• Confirm that the wall mains socket outlet has adequate
electrical capacities. Failure to do so may cause fire or
a power failure to all of the equipment connected to
the same power circuit.
• Do not bend, pull or twist the power cord. Equipment
damage including separation of the power plug and
disconnection of the cord wire as well as fire or
electric shock can result.
• Do not use the adapter which power cord plug
changed into 3-pin to 2-pin. Electric shock may result.
CAUTION
• Use the power supply which suits the specification in
"Specifications" on page 31 in "Appendix".
Otherwise, malfunction may result.
• Be sure to connect the power plug securely.
Otherwise, the equipment will not function.
• Do not use of a power supply with insufficient
electrical capacities. Otherwise, malfunction may
result.
• Be fully careful for the power cord not to disconnect.
If the power cord disconnects while in use, the picture
under printing disappears or it may not be printed
correctly.
• Do not connect or disconnect the power cord while
power ON. Otherwise, malfunction may result.
To connect to the AC mains power supply
1
Confirm that the color video printer (OEP-4) is
turned OFF.
2
Connect the power cord provided with the mobile
workstation to the AC mains power inlet of the
color video printer (OEP-4) (see Figure 2.4).
Power cord
Figure 2.4
3
Connect the power cords of the ancillary equipment
to the mobile workstation by referring to its
instruction manual.
4
Connect the power cord of the mobile workstation
to a wall mains socket outlet.

2.4 Connection to the AC Mains Power Supply

AC mains power inlet
13
2