Restart Printing - Olympus oep-4 Instructions Manual

3
Remove the one screw with which the back cover
plate is secured, using a coin and so on (see Figure
4.5).
Figure 4.5
4
Pull the back cover plate up and remove it from the
main body (see Figure 4.6).
Figure 4.6
5
Remove the jammed paper slowly (see Figure 4.7).
Figure 4.7
6
Replace the back cover plate (see Figure 4.8).
Figure 4.8
7
Secure the back cover plate by the screw removed,
using a coin (see Figure 4.9).
Confirm that the screw holes of back side of the
main body and the back cover plate match before
securing them.
Figure 4.9
8
Reset the paper tray and ink ribbon holder into the
color video printer (OEP-4).
Reconnect the power cord and other connecting
cables as they were.
Confirm that any connecting cables and the power
cord are securely connected.
NOTE
If jammed paper cannot be not removed or error
message is displayed even after taking the above
procedure, stop using this instrument and contact
Olympus.

Restart Printing

Even when paper jam occurs in the middle of printing,
the image of the print is held in the flash memory of this
instrument so it can be re-printed.
4.3 In the Case of a Paper Jam
4
27