Setting Projector Information [Projector Info.] - Canon WUX5000 User's Manual & Installation Manual

Setting Up the Network
Item
SNMP
Receive community
Password
Confirm password
SNMP trap
Trap IP address
Trap community

■Setting Projector Information [Projector info.]

From [Projector info.] in the settings window, you can set the names and location
names which are used to identify projectors when multiple projectors are installed on
the network. For the setting procedure, refer to
Item
Projector name
Location
Downloaded From projector-manual.com Canon Manuals
Explanation
Select the SNMP function version. If OFF is
selected, the SNMP function will be turned
off and the other settings in this window
cannot be changed.
Enter the community name which will
receive projector information in 1-byte
alphanumeric characters and symbols (1 -
15 characters).
Enter the community settings password in
1-byte alphanumeric characters and sym-
bols (8 - 15 characters). This is also used
as the password for trapping. It can be set
only when the SNMP version is V3.
For confirmation, enter the same password
as you entered in [Password].
Select the type of error to trap. When any of
the checkboxes is turned on, it becomes
possible to set [Trap IP address] and [Trap
community].
Enter the IP address to send information to
when trap occurs. Enter in 1-byte numbers.
Enter the community name which will send
information when trap occurs. Enter in 1-
byte alphanumeric characters and symbols
(1 - 15 characters).
Explanation
Enter the projector name in 1-byte alphanu-
meric characters and symbols (1 - 63 char-
acters).
Enter the projector installation location in 1-
byte alphanumeric characters and symbols
(0 - 63 characters).
186
Factory default setting
OFF
<Blank>
<Blank>
<Blank>
OFF (no checkmarks)
0.0.0.0
<Blank>
page 177.
Factory default setting
WUX5000 / WUX4000 /
WX6000 / SX6000
<Blank>