Setting Up Your Projector - Canon D-50P User Manual

Setting up your projector

Setting up the screen
Install the screen perpendicularly to the projector. If the screen can not be installed in such a way, adjust the
projection angle of the projector. (See page 11.)
• Install the screen and projector so that the projector's lens is placed at the same height and horizontal position of
the screen center.
• Do not install the screen where it is exposed to direct sunlight or lighting. Light directly refl ecting on the screen
makes the projected images whitish and hard to view.
Screen size and projection distance
Refer to the following table to determine the screen size and projection distance.
Front projection
W
W1
Screen size
Width Height
Diagonal size
(W) (H)
inch cm inch cm inch
40 102 32 81 24
60 152 48 122 36
80 203 64 163 48
100 254 80 203 60
150 381 120 305 90
200 508 160 406 120
250 635 200 508 150
300 762 240 610 180
• The above fi gures are approximate and may be slightly different from the actual measurements.
• The lens shift height and width show distances from the factory default position.
• Depending on the installation conditions, warm air that is emitted from the exhaust vents may fl ow into the intake
vent, causing the projector to display "TEMPERATURE!!" and then stop projecting images.
W1
Center of the lens
L
Maximum projection area
Projection distance (L)
Shortest Longest
(Wide) (Tele)
cm inch m inch m inch
61 54 1.4 74 1.9 12
91 82 2.1 112 2.8 18
122 110 2.8 150 3.8 24
152 138 3.5 189 4.8 30
229 208 5.3 284 7.2 45
305 279 7.1 380 9.7 60
381 349 8.9 - - 75
457 419 10.6 - - 90
Front projection, ceiling mounting
W
W1
Lens shift height
Lens shift
width
H1 H2
(W1)
cm inch cm inch cm
30 2 6 3 8
46 3 9 5 12
61 4 11 6 16
76 6 14 8 20
114 8 21 12 30
152 11 28 16 41
191 14 36 20 51
229 17 43 24 61
EN-10
W1
Center of the lens
L
Maximum projection area