Clevo W170HN Service Manual page 36

Processor Installation Procedure
1. Insert the CPU (Figure 9a), pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE
A
IT!), and turn the release latch
2. Remove the sticker (Figure
C
3. Insert the heat sink as indicated in
D
4. Tighten the CPU heat sink screws in the order
5. Replace the component bay cover (don't forget to replace the fan cable) and tighten the screws
a.
A
b.
B
lock
towards the lock symbol (Figure
B
9c) from the heat sink.
Figure 9d.
, & (the order as indicated on the label and
1 2 3
c.
d.
1
D
2
3
9b).
Figure
(page 2 -
C
Note:
Tighten the screws
in the order as indi-
cated on the label.
Removing and Installing a Processor 2 - 13
Disassembly
Figure 9
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
9d).
wards the lock symbol.
9).
c. Remove the sticker from
the heat sink and insert
the heat sink.
d. Tighten the screws.

A. CPU
D. Heat Sink
• 3 Screws