Error Code - Konica Minolta BIZHUB 131f User Manual

16

16.2.5 Error code

Dialing errors
D.0.3,
D.0.8
D.0.2
D.0.6,
D.0.7
Reception errors
R.1.1
R.1.2
R.1.4
R.2.3
R.3.1
R.3.3
R.3.4
R.4.1
R.4.2
R.4.4
R.5.1, R.5.2
R.8.1
R.8.10
R.8.11
Downloaded From ManualsPrinter.com Manuals
16-26
Maintenance and Troubleshooting
The remote unit didn't respond, the call couldn't be completed or
stop was
pressed during dialing. Re-try the call. If your machine repeats the
message, call the remote fax unit's operator and verify that unit is
operating properly.
The remote unit is busy. Try the call again.
Either the remote unit didn't respond, the call somehow didn't go
through or
[Stop] was pressed during dialing. Try the call again.
The calling fax machine didn't respond to your fax machine. This
can happen if someone dials a wrong number or if the remote ma-
chine restricts access through use of a passcode.
The two fax machines were incompatible. Your machine sends
and receives only ITU-T Group 3 fax communication, the industry
standard since the early 1980s.
Someone pressed [Stop] at the receiving fax machine.
Poor phone line conditions made fax communication impossible.
Call someone at the remote machine's location.
The sending fax machine detected too many errors from the re-
ceiving fax machine.
The sending fax machine is incompatible or had a document fee-
der problem during transmission.
Poor phone line conditions may have prevented your fax machine
from properly printing some or all of the pages it received.
The machine received too large length data that over your machi-
ne's limit.
Either the line disconnected before transmission or the transmit-
ting fax machine needs maintenance.
The machine has reached its memory capacity.
ECM reception failed (perhaps due to line noise).
A compatibility error occurred.
Line noise or other problems prevented line probing.
The fax machine timed out while waiting for the retrain signal.
bizhub 131f/190f