HighSecLabs SC21H-3 User Manual page 34

Dragging a Window
In order to move a window user should first switch to system mode.
In system mode, hold the left mouse button when the system cursor
located on the desired window and the window will move. Release
left mouse button to drop window in place.
Notes: Window movement to the left side is limited by the display
boundary.
Window movement to the right side is unlimited (window may be
pushed out of the display viewable area).
Window Resizing
In order to resize a window the user should first switch to system
mode by pressing + or – mouse side buttons. In system mode, the
user should drag the mouse while holding the right mouse button
when the system cursor located on the bottom right corner of the
desired window. Release right mouse button to freeze window size.
Note: Window size is limited by the size set for the window under the
channel menu.
Window Internal Scroll
When window size is smaller than input image size it might be
required to "move" the image inside the window. This is done by
pointing at the window, pressing both mouse buttons at the same
time and moving the mouse. Release the mouse buttons to freeze
the position of the window.
Preset buttons
Preset buttons located at the task bar marked as 1, 2, and 3 enable
window arrangement saving and loading.
Preset buttons are useful to store user specific settings for specific
job environments.
34
Section 4 - Operation
It should be emphasized that preset stores only windows
configuration. No other settings or data is stored.
To save a setting the user should click on one of three preset buttons.
As the save process starts the button will show a small progress bar.
After loading, clicking the preset button will load preset KVM
configuration.
To select a pre-configured preset either click the preset button on the
system bar or use the CTRL , CTRL , F1-4.
Note: The presets will also save the scaling factor of the window is
applicable.
Maximizing a window
To maximize a window to its full size – enter System Mode by pressing
+ or – mouse side buttons then bring the system cursor to the
window that should be maximized and then double click on that
window.
The selected window will maximize to its native input resolution.
To leave maximize mode – change back to system mode (by pressing
the mouse side buttons) and re arrange windows as needed.
Deactivating / Activating channels
The user can remove from the KVM Combiner display inactive
channels. In order to deactivate a channel the user should enter
system mode and then move the system cursor to the desired
channel button at the task bar and double-click on it. Red X
should appear on that channel (see figure below).
In some cases the user may want to deactivate a live channel
for operational reasons. The Combiner will display instead on
that channel a background color.
2/4 Ports Secure KVM Combiner User Manual