Part Ii Installation And Setup; Installation -Wedge Interface - Opticon 25-ULGPMU01-01 User Manual

Manual No. 25-ULGPMU01-01 Series LGP Handheld CCD Scanner

Part II Installation and SetUp

This section of the manual contains information on the physical installation of the scanner as well as certain programming options.
There is a separate section for each type of interface. Check to see which type of interface your scanner has and turn to that
section for information on installing the scanner
A.) Installation – Keyboard Wedge Interface
A "Y" connection cable is required for installation. The scanner is installed or "wedged" between the keyboard and the computer..
Your "Y" cable should have connectors for both a PS2 and AT type installation. The "Y" cable connects both the scanner and the
keyboard to the computer.
The scanner must match the type of computer being used. The default setting is for an IBM AT type computer. If this type does
not match the host computer, refer to the "Computer Type Selection" in the programming section that follows. If the connector
does not match the host compute remove the short cable section, reverse it and insert it in the other connector
Page 5