Setup; Display Setup - ACU-RITE 06024 Instruction Manual

SETUP

Display Setup

1
Install External Monitor or Sensor Batteries
BEFORE powering on the display, install batteries for all external Monitors
and/or Sensors (sold separately) that you would like to synchronize with
the display.
A-B-C
Channel
NOTE: If pairing more than one wireless sensor (model 06002 or 06044) with the display,
the A-B-C channel must differ between each sensor. Verify that each sensor has a different
channel selected by following the instructions in the corresponding sensor manual.
2
Plug in Power
Adapter
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment that will not be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
A-B-C
Channel
IMPORTANT: Batteries are a backup power source
to preserve records in the event of a power outage.
Power adapter is required as the primary power
source to enjoy the full functionality of this product.
6
3
Install Backup Batteries
3 AAA batteries (optional)