Programmable Alarms - ACU-RITE 06024 Instruction Manual

the highest and lowest values recorded since the unit was powered on. A
timestamp is shown in the clock area of the display indicating when the record
values were recorded.
To manually clear the records currently being viewed, press and release the
CLEAR button, located in the battery compartment of the display. Dashes
display to confirm you have cleared the record currently being viewed.

Programmable Alarms

This display features programmable alarms that sound an alert to notify you
when a value (for temperature, humidity, etc.) has been reached or exceeded.
When an alarm is triggered, the display emits an audible beep and flashes data
in the affected category. You can customize the alarms by turning ON or OFF
the alarms you'd like activated or deactivated, and most alarms allow you to
input your own values to trigger the alarm. By default, the water detector alarm
is preset to ON.
Setup an Alarm
1. Press and release the color-coded button next to a location on the display
for which you wish to set an alarm.
2. Press and release the "
3. Press and release the "
set an alarm is highlighted on the display. "ALARM OFF" will flash.
4. Press and release the "▲" or "▼" buttons until "ALARM ON" appears.
5. Press and release the "
location.
6. Repeat steps 3-5, as needed.
Edit an Alarm
1. Press and release the color-coded button next to a location on the display
for which you wish to update an alarm.
2. Press and release the "
3. Press and release the "
adjust an alarm for is highlighted on the display.
4. Press and release the "SET" button. "SET ALARM" will be shown.
5. Press and release the "▲" or "▼" buttons to adjust the reading's HIGH
value.
6. Press and release the "SET" button.
7. Press and release the "▲" or "▼" buttons to adjust the reading's LOW
value.
8. Press and release the "SET" button to end alarm adjustments, OR press and
release the "
" button to enter alarm SET MODE.
" button until the reading for which you wish to
" button to cycle to the next reading for the
" button to enter alarm SET MODE.
" button until the data reading that you wish to
" button to adjust the next reading's values.
13