Page 1
Changing the Encoder Resolution on a DRO10X...
Page 2
Changing the Encoder Resolution on a DRO10X Take note of the resolution listed on the encoder label and also which port the encoder you need to change is plugged into. You will need this information for later.
Page 3
Changing the Encoder Resolution on a DRO10X Power up the box. When prompted, press any key to continue. The power switch is located on the back, directly under the power cord.
Page 4
Changing the Encoder Resolution on a DRO10X Reference your encoders by moving each axes so they cross at least 2 reference marks on the glass (~3“).
Page 5
Changing the Encoder Resolution on a DRO10X Press the Menu button.
Page 6
Changing the Encoder Resolution on a DRO10X Use the up and down arrow keys to highlight the Installation Setup menu, and then press enter.
Page 7
Changing the Encoder Resolution on a DRO10X Use the up and down arrow keys to highlight the Encoder Setup menu, and then press the right arrow key.
Page 8
Changing the Encoder Resolution on a DRO10X Use the up and down arrow keys to highlight the port the encoder you want to change resolution on is plugged into, and then press enter.
Page 9
Changing the Encoder Resolution on a DRO10X Use the up and down arrow keys to highlight the Resolution menu, then press the right arrow key.
Page 10
Changing the Encoder Resolution on a DRO10X Use the up and down arrow keys to highlight the resolution that matches the encoder label, and then press enter twice.
Page 11
Changing the Encoder Resolution on a DRO10X Hit the left arrow key three times to get back to the DRO screen. Repeat this sequence for additional encoders as needed.