Lancom 1821n Wireless Manual page 30

The power LED is blinking and no connection can be
made?
If the power LED blinks red and no WAN connections can be
established, there is no cause for concern. This merely means
that a pre-set charge or time limit has been reached.
There are three ways to remove the lock:
Reset the toll protection.
Increase the limit.
Deactivate the lock completely (set limit to '0').
LANmonitor shows you when a charge or time limit has been reached. To reset the toll protec-
tion, activate the context menu (right-mouse click) Reset charge and time limits. The charge
settings are defined in LANconfig under Management
lable if the 'Complete configuration display' is activated under Tools
With WEBconfig, charge protection and all parameters are to be found under LCOS menu tree
Setup Charges
·
Online The online LED displays the general status of all WAN interfaces:
Off
Green
Green
Green
Red
Orange/
green
Orange /
red
LANCOM 1811n Wireless – LANCOM 1821n Wireless
Reset budgets.
No active connection
Flashing Opening the first connection
Inverse flashing Opening an additional connection
On (perma- At least one connection is established
nently)
On (perma- Error establishing the last connection
nently)
In the housing At least one WLAN module is in managed mode and has not
cover; blinking found a WLAN Controller yet. The corresponding WLAN
alternately with module(s) is/are switched off until a WLAN Controller is
the power LED found to supply a configuration, or until being switched
manually into another operating mode.
In the housing At least one WLAN module is in managed mode and has
cover; blinking found a WLAN Controller. However, the WLAN Controller
alternately with cannot assign a configuration because the firmware and/or
the power LED the device's loader version is not compatible with the WLAN
Controller.
Chapter 2: Installation
Costs (these settings are only avai-
Options).
Signal that a
charge or time
limit has been
reached
29