Setting The Scsi Id Number - Epson GT-10000+ Setup Manual

Setting the SCSI ID number

The scanner's default SCSI ID number is 2.
If you add the scanner to a system in which one of your SCSI
devices already has a SCSI ID of 2, change the ID number to an
unused number using the rotary switch. See the table below as a
guide.
ID Availability
0 Not recommended
1 Not recommended
2
3
4
5
6
7 May not be available
c
Caution:
Do not set the SCSI ID to an ID number that is already assigned
to another device; otherwise the computer, scanner, and other
devices will not operate properly.
The SCSI ID rotary switch
is located at the rear of
the scanner.
Description
Usually used for hard disk
Usually used for hard disk
Factory setting of the scanner
Usually used for the SCSI board
Setting up the Scanner
2
2-9