Changing The Input Display - Onkyo HT S3200 Instruction Manual

First Time Setup—Continued
2 Use the Up and Down [ ]/[ ]
buttons to select "2.Digital
Audio", and then press [ENTER].
3
Use the Up and Down [ ]/[ ]
buttons to select an input
selector, and then use the Left
and Right [ ]/[ ] buttons to
select:
COAX: Select if the component is
connected to DIGITAL IN
COAXIAL.
OPT1: Select if the component is
connected to DIGITAL IN
OPTICAL 1.
OPT2: Select if the component is
connected to DIGITAL IN
OPTICAL 2.
: Select if the component is
- - - - -
connected to an analog input.
4 Press the [SETUP] button.
Setup closes.
Notes:
• Make sure you also set your digital sources to send out
a digital signals. Please refer to the digital sources'
manual.
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.

Changing the Input Display

If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TV/TAPE
IN/OUT jacks, or connect an RI Dock to the CBL/SAT
IN or VCR/DVR IN jacks, for
must change this setting.
This setting can only be changed on the AV receiver.
1
2
to work properly, you
Note:
DOCK can be selected for the TV/TAPE or CBL/SAT or
VCR/DVR input selector, but not at the same time.
CBL/SAT TV/TAPE
VCR/DVR
Press the [TV/TAPE], [CBL/SAT]
or [VCR/DVR] input selector
button so that "TV/TAPE",
"CBL/SAT" or "VCR/DVR"
appears on the display.
or or
or
Press and hold down the
[TV/TAPE], [CBL/SAT] or
[VCR/DVR] input selector button
(about 3 seconds) to change the
setting.
Repeat this step to select MD, CDR, or
or or
DOCK.
For the TV/TAPE input selector, the
setting changes in this order:
o o
TV/TAPE MD
DOCK
or
For the CBL/SAT input selector, the
setting changes in this order:
l
CBL/SAT DOCK
For the VCR/DVR input selector, the
setting changes in this order:
l
VCR/DVR DOCK
CDR
37